MHC wrote
I don't want to set-off an explosion in a piece of plastic!
JayGrym wrote
Metal 3D Printing exists!
MHC wrote
Again the result is very rough. So much finishing would be required.
JayGrym wrote
Not that the machine is affordable lol
MHC wrote
I saw a 3D printer built from a kit, and then operated. The construction involved a lot of swearing! And it needed to have a room-heater under its table, to stop the work-in-progress from peeling off its substrate! The result was very rough, so I expect that finishing would be required.
Viewing a single comment thread. View all comments